Fiets.nl

skimons schreef: pedalen niet te vast zetten. krijg je ze ook makkelijk weer los. succes!

Pedal Threading
Direction
The right pedal has a normal thread, but the left pedal has a left (reverse) thread.
The reason for this is not obvious: The force from bearing friction would, in fact, tend to unscrew pedals threaded in this manner. It is not the bearing friction that makes pedals unscrew themselves, but a phenomenon called "precession".

You can demonstrate this to yourself by performing a simple experiment. Hold a pencil loosely in one fist, and move the end of it in a circle. You will see that the pencil, as it rubs against the inside of your fist, rotates in the opposite direction.

Ignorant people outside the bicycle industry sometimes make the astonishing discovery that the way it has been done for 100 years is "wrong." "Look at these fools, they go to the trouble of using a left thread on one pedal, then the bozos go and put the left thread on the wrong side! Shows that bicycle designers have no idea what they are doing..."

Another popular theory of armchair engineers is that the threads are done this way so that, if the pedal bearing locks up, the pedal will unscrew itself instead of breaking the rider's ankle.

The left-threaded left pedal was not the result of armchair theorizing, it was a solution to a real problem: people's left pedals kept unscrewing! I have read that this was invented by the Wright brothers, but I am not sure of this.

Note! The precession effect doesn't substitute for screwing your pedals in good and tight. It is very important to do so. The threads (like almost all threads on a bicycle) should be lubricated with grease, or at least with oil.

scepticus schreef:Nee, je trapt ze juist vast.

Als je trapt draaien ze naar achteren maar daardoor 'rolt' de pedaalas juist naar voren in de crank en zet hij zich vast.